Drill rigs
Remote control for drill rigs
Drill rigs put remote systems through constant vibration, dust, and mud — reliability matters more here than almost anywhere else on site.
Drill rigs put remote systems through constant vibration, dust, and mud — reliability matters more here than almost anywhere else on site.
Drilling applications put remote systems through constant vibration, dust, and mud ingress — reliability and a rugged housing matter here more than almost any other application. We supply transmitters and receivers matched to the control systems already fitted to your rig.
Connector corrosion, battery seal failure, and control panel damage from mud and debris are the most common faults we see on drill rig transmitters — all repairable without a full replacement.
Official Australia & New Zealand distributor for IMET remote control systems — genuine parts, factory-trained repairs, and full technical support.
Shop IMET parts5 products in this category
Not running IMET? We carry parts and offer repairs for the other systems already installed across AU and NZ.
Only if it's rated for the vibration and ingress the application sees — send your data plate photo and we'll confirm the right fit or match a suitable upgrade.
In most cases yes, provided it's assessed before corrosion sets in on the internals — get it to us as soon as a fault shows up.
Yes — while IMET is our distributed line, we carry parts and offer repairs for most major brands fitted to drill rigs across AU and NZ.